How do I connect my Tenda Extender to my router?
How do I connect my Tenda Extender to my router?
① Plug the extender (A9) into an electrical outlet near your WiFi router. login domain name re.tenda.cn or default login IP address 192.168. 0.254 into the address bar, and click Go. ④ When the extender’s web UI appears, select the WiFi name (SSID) you want to extend, and click Next.
Why is my Tenda router not working?
You can reset the Tenda device to factory default there. ii. Find a Reset or RST button/hole on the side of the Tenda device and hold down it for about 10 seconds. During which time, you will find that all the indicators turn on or off and several of them will back off or on later.
Can’t connect to Tenda wireless router?
You can try solutions as below.
- Power cycle your modem and the Tenda device.
- Change the LAN IP address in the setup page.
- Clone the MAC address.
- Change the DNS Address.
- Change the MTU value.
- Change the WAN speed in setup page.
- Reset the Tenda device to factory default.
- Upgrade to a newer firmware.
How can I reset my Tenda wifi extender?
Step 1: Open bowser and enter plc.tendawifi.com in address bar to login the setup page. Step 2: Choose “Administration” > “Device Management”. Step 2: Tap “OK” to reset the device.
What is the IP address of Tenda router?
192.168.0.1
The default LAN IP address of Tenda router is 192.168. 0.1. You can change the LAN IP address to 192.168. 10.1, then click Apply and the router will reboot.
Which lights should be on my Tenda router?
4 Please check the LED lights on the router after connection. Make sure SYS light is blinking, WLAN light is on or blinking, one of LAN ports(1,2,3,4) is on, WAN light is on or blinking.
What is the password of Tenda WIFI?
Tenda Router Login Guide The default username for your Tenda router is admin. The default password is admin.
What is the default username and password for Tenda router?
Open a browser or safari, then input 192.168. 0.1 in the address bar, click Enter. 3. Input the default username and password “admin, admin”, click Login to go into the homepage.
Why is my Tenda router blinking?
LED Status Description POWER Solid Indicates a proper connection to the power supply SYS Blinking Indicates system is functioning improperly WAN Solid WAN port connected correctly Blinking WAN port is transferring data WLAN Solid Wireless is enabled.
How do I reset my Tenda router to factory settings?
Method 1:
- Step 1: Open the browser and input plc.tendawifi.com in address bar to login setup page.
- Step 2: Choose “System”
- Step 3: Tap “Reset” button.
- Step 1: Find the Reset button on the side of the PLC.
- Step 2: Press the reset button for 8 seconds until all lights on and then off few seconds later.