How do I show HSRP in Packet Tracer?

How do I show HSRP in Packet Tracer?

Roles of Routers in HSRP Configuration.

1. Step 1:Draw the HSRP Topology Diagram in Cisco Packet Tracer.
2. Step2: Assign the IP Address to PC and Server with Gateway IP .
3. Step 3: Important Points to be kept in Mind During HSRP Configuration.
4. Step 4: Virtual Router Role in HSRP.
5. Step 5: HSRP configuration on Router R1:

Does Packet Tracer support HSRP?

HSRP can be configured in the same way in Cisco catalyst 3560 and 3650 multilayer switch vlan interfaces using Cisco Packet Tracer.

How do I configure HSRP on my router?

Configure HSRP version 2 between R1 and R2 using the IP addresses 10.10. 10.1/24 (R1) and 10.10. 10.2/24(R2) and a virtual IP address of 10.10….Table 3 – R2 Example Configuration.

How do I enable HSRP?

To achieve basic HSRP configuration, you need to do the following:

1. Configure normal IP address on interface (cannot be the same as HSRP virtual IP)
2. Bring interface up (no shutdown)
3. Configure HSRP group and virtual IP address using the standby command.

How do I find the HSRP command?

Showing HSRP State Information

1. Problem. You want to see current HSRP information, such as which router is primary.
2. Solution. To view the HSRP information, use the following EXEC command: Router2# show standby.
3. Discussion.

What is HSRP command?

The hsrp ipv4 command activates HSRP on the configured interface. If an IP address is specified, that address is used as the designated address for the Hot Standby group. If no IP address is specified, the virtual address is learned from the active router.

Can 2 HSRP routers become active active?

In HSRP, two or more routers give an illusion of a single virtual router. This allows you to configure two or more routers as standby routers and only a single router as the active router.

What is HSRP group number?

An HSRP group can be assigned an arbitrary group number, from 0 to 255. If you configure HSRP groups on several VLAN interfaces, it can be handy to make the group number the same as the VLAN number. However, most Catalyst switches support only up to 16 unique HSRP group numbers.

What is Cisco HSRP configuration?

HSRP is Cisco’s standard method of providing high network availability by providing first-hop redundancy for IP hosts on an IEEE 802 LAN configured with a default gateway IP address. HSRP routes IP traffic without relying on the availability of any single router.

Which command enables HSRP on a Cisco IOS device?

Related Commands

How do I check the HSRP status on my Cisco router?

What is HSRP in Cisco switch?