How do you calibrate a badger water meter?
How do you calibrate a badger water meter?
Turn power to meter off and record calibration number. Set calibration number on board to 9999. Disconnect wires going to terminal 1 and 2 from meter transmitter (Green and black wires coming from underneath board). Attach jumper wire to terminal one, turn power to meter back on.
How do you read a Badger Meter water meter?
The Badger ADE meter is read from left to right. The first 4 numbers are the 1000’s that we read (example – 453,286 gallons total went through this meter since it was installed). If the RED circle is moving, there is water currently flowing through the meter. The Sensus meter is read from left to right.
Can a badger water meter be installed vertically?
Not to be mounted vertically. Never put the meter upside down or canted on its side as it will not function correctly. 2/ Water meters should always be fitted with a minimum of 10x pipe diameter both up and downstream.
How much does it cost to calibrate a flow meter?
between $5,000 to $75,000 USD
A facility that has a meter bolted to downstream and upstream piping at ground level will have lower costs. The cost of flow meter calibration varies between $5,000 to $75,000 USD.
How do you calibrate a water meter?
Place an aliquot (small portion) of process fluid in a test meter and weigh it for a precise amount of time while it flows 60 seconds. Use a calibrated scale to obtain an accurate measurement of the weight of test fluid. After the test period is completed, divert the test fluid into a discharge container.
What are water meters made of?
It is made of high-impact plastic, brass, and stainless steel. The measurement register is made up of a clear plastic bubble over the odometer-type or LCD gauge. These meters can also be installed in separate spaces of an apartment to measure individual water usage.
Can water meters be installed upside down?
Never put the meter upside down or canted on its side as it will not function correctly. 2/ Water meters should always be fitted with a minimum of 10x pipe diameter both up and downstream.